View Single Post
  #4  
Old 24-02-17, 18:05
Eric B Eric B is offline
Registered User
 
Join Date: Jun 2007
Location: Canada
Posts: 580
Default holes

Hello

The M38A1 was used by the 2 CMBG Signal and HQ Squadron, therefore it could be an additional antenna mount for a 3 radio configuration. Not sure what type of radio or mount could have been used.

The holes were drilled into the original body, which had the patch kit done to it.

At the end of its life it served in Kingston, CDE, Concept Development and Experimentation, or so I was told. It was a test platform, but the holes might not have been part of the testing.

The holes at in the right rear side. CDE was stencilled onto the left rear bumperette.

I am still trying to figure out what the older style markings were for 2 CMBG Signals and HQ Squadron.
I know it was white over blue with a white strip over the top. There would have been a red number and writing would have been in the white strip. Possibly a number 2 and 2CMBG SIG &HG ?

Thanks
Eric
Attached Thumbnails
Scan_20150727 (28).jpg   Scan_20150727 (29).jpg  
__________________
Collecting data on the WW2 Canadian jeep and trailer.
Serial, WD Numbers etc.
Reply With Quote