Thread
:
VICKERS MK6B's resto
View Single Post
#
166
12-04-17, 05:26
colin jones
Registered User
Join Date: Jun 2007
Location: Adelaide
Posts: 1,810
Well that's it!! i've welded the bottom on so I hope I don't need to do anything else in there or I'll be cutting a hole
. Centre lines all lines up, the gears all mesh well and I can turn the main shaft and get the gears to respond so that's a plus. One of the bearing housings in the centre must have got a little bit too hot so I will have to do a bit of mods with my die grinder but no biggy. The outside wing parts are next then the holes and tapping.
Attached Thumbnails
colin jones
View Public Profile
Find all posts by colin jones