The three individual Coil Assembly leads at the back of the receiver have now been disconnected.
When I looked at the V1C Pin the longest lead had been connected to afterwards, it seemed bent back somewhat and it had a large blob of old solder stuck to it that appeared as is it could be a path to ground, so I put the soldering iron on it and pulled a drop of solder off, the size of a BB pellet. I also returned the Pin to a more vertical position. Better to be safe than sorry.
Tomorrow will be an ‘Errands Morning’, but I hope to next get the Sharp/Flat Switch Knob removed from the front of the receiver and the two mounting screws for this switch removed so I can free the switch assembly up and see how much free play I might be able to gain on the Coil Assembly main harness.
I will be thinking ‘happy thoughts’ tonight.
David
|