View Single Post
  #953  
Old 08-11-18, 09:05
colin jones's Avatar
colin jones colin jones is offline
Registered User
 
Join Date: Jun 2007
Location: Adelaide
Posts: 1,810
Default

Of course the picture are about face. Anyway after the disc is welded to the small shaft I will need to face it off on the lathe and then drill, dowell and bolt the clutch housing to the end. There will be some serious torque on this part.
Attached Thumbnails
20181108_171757.jpg   20181108_171808.jpg   20181108_171833.jpg  
Reply With Quote