Nice work.....
My rear wall bolts on top of the dot and dash floor plate so I will have to use a rubber gasket/antisqueak soft enough to conform to the floor plate design.
I tested the bare wall frame and the holes do line up...... for now.
Been playing with test pieces trying to roll the proper curve at each end but with a full length / full width piece it is a bitch to hold over head when doing the second curve. Hoping to have a close fit.... preshaped panel that will require minimum clamping and gluing.
Was just toooooo hot and sticky for that kind of work today!!!!
Cheers
__________________
Bob Carriere....B.T.B
C15a Cab 11
Hammond, Ontario
Canada
|