View Single Post
  #5  
Old 12-10-17, 03:22
Mike Kelly's Avatar
Mike Kelly Mike Kelly is offline
Fan of Lord Nuffield
 
Join Date: Feb 2003
Location: Victoria Australia
Posts: 5,607
Default bore

Alex

When measuring the bores, you can use a telescoping gauge. Cheap gauge sets are available on ebay , you use a micrometer to place across the telescopic gauge. The best gauges are Moore & Wright made in England or similar, the modern Asian sets are OK but you get what u pay for .

Measure at the lower end of the bore, right down inside, this is where the bore wear is at a minimum . I've got new sets of Hastings rings +30 and NOS domed pistons +30 and 40 . Standard pistons , I reused the standard pistons in the C8 engine with a hone and chrome faced rings from another engine ! , only problem is a rattling gudgeon pin on one piston, hear it after warm up but its not the end of the world.
__________________
1940 cab 11 C8
1940 Morris-Commercial PU
1941 Morris-Commercial CS8
1940 Chev. 15cwt GS Van ( Aust.)
1942-45 Jeep salad
Reply With Quote