The small gear puller I had ordered from Princess arrived this afternoon from Brandon. Interesting that it shipped last week but took three business days this week to make the tracked run into Winnipeg.
In any event, it is now set up on the PA TUNE Drive Knob and under load. As you can see, the front panel of the Sender has been covered with heavy cloth and I added a C-Clamp to the jaws of the puller to add another level of protection to everything, should the knob suddenly break free when I am not around.
The plan is to run the puller screw down one quarter turn each half day for the next little while and see how it goes.
May The Force Be With Me!
David
|