Morris c8
I had the head off again today, doubts in mind mean going backwards. I was going to elongate the water pump holes but the wall thickness doesn't allow so I filled the original holes in the cylinder head and drilled & tapped new ones where they will fit, all good and removed a broken bolt that was causing some problems. The head was measured again for clearance and as I previously measured the pistons have .100" clearance as the pistons are .020" under the case and the gasket is a squashed .080" so all good. Should get good pressure which I will check in a few days, I added a picture of the head just to remind myself what lurks below. Thanks every one.
Paul
|