View Single Post
  #12  
Old 27-01-06, 03:55
Jordan Baker's Avatar
Jordan Baker Jordan Baker is offline
Moderator
 
Join Date: Feb 2003
Location: Hamilton, Ontario, Canada
Posts: 4,000
Default

Hi everyone

This thread has become really good from my original comments. Ok this is the setup I have installed in my UC. Ive used steel brake line tubing for the fuel lines. From pump to Carb is a 10" 5/16 line. Would this shape cause me any problems with traping air bubles?

Is there any suggestions for improving it. The tank to pump line is the same kind of tubbing but I have also installed an outboard motor primer bulb (thanks Charlie). What kind of fuel filter should I put in or is it needed if I have my original tank cleaned out and resealed/relined.
Attached Thumbnails
fuel line.jpg  
__________________
Jordan Baker
RHLI Museum,
Otter LRC
C15A-Wire3, 1944
Willys MB, 1942
10cwt Canadian trailer
Reply With Quote