[David Dunlop]

Most of the lower section of the content label that broke loose in the inside of the tool box lid survived as the three small pieces found in the bottom of the box when received. It is now time to glue them back in place.

I initially thought the original glue might have been mucilage but then realized that glue is always water soluble and the label would have been completely gone by now, had that been the glue used. Looking at some of the surviving glue, I now suspect Canadian Marconi used the same glue as they were using in their Cabinet Division.

I have decided to go with the Elmer’s Gel Glue for refitting the pieces of label. It is a water-based glue that stops being water soluble when cured. Being a gel it does not run and it has a nice working time so I can fiddle with tweezers for a bit to get the three pieces of paper properly placed before the glue sets up.


David