Sender Resistance Testing
All of the required resistors have now been tested and I have just started looking into the capacitors. To complete that portion, I will need to remove the circuit board mounted on the rear chassis skirt, shown in the second photo in Post #949, and I will have to study that setup a bit first, before removing the three mounting screws holding it in place.
I also discovered that it is possible to carefully spin the cardboard sleeves on those four capacitors around their metal cores, so I was able to wipe all the dust and dirt off them all and expose the sides showing their PC-Numbers and Stats. In addition, as Chris had suggested, I was able to ID two of these capacitors by cross reference to the 19-Set Documentation. So now all four of them are identified
I will sort the resistor results shortly and post them
David
|