[Phil Waterman]

Hi Bruce

Just went out checked, my 1945 HUP, no cast spacer visible only a rubber spacer 1/8 to 1/4 inch thick. Possible way to confirm, if your body is mounted on frame, find the two mounting brace holes on the body and the corresponding holes on the radiator U frame. The body end brackets should be on the sides of engine opening. The radiator support rod run horizontal to match hole in the U frame. Then measure down to the HUP frame. Or if the U frame is loose from radiator just test fit to find the thickness of rubber spacer.

Hint the two mounting rods are different one has a dog leg bend.


Memory is saying there are rubber strips on both sides of the frame under the U frame and that there is a metal plate under the HUP frame for the two bolts. The little plate is the size of the rubber spacer it in place and that it has two bend tabs to make sure the nuts don't come loose. Memory also says the radiator U frame has square holes to hold carrage bolts.

Believe purpose of spacer and sprins is allow for more body twisting on trucks. While HUP series the body is bolted rigid to the frame. This rigid body frame bolting did cause some cracks in the body and its sub frame.