Quote:
Originally Posted by cletrac
It's starting to look the part. I have about 7 hours into it so far. The ends on the wires that go to the set are offset almost half an inch so the terminals stick out about 1 1/4 ".
There's 4 bolt holes below the bottom gauge that must hold the condensers on the inside. Now to make the switch mounting plates.
|
Not wishing to rain on your parade, but the original unit most likely had a plastic (ebonite or Tufnol) panel with the lettering engraved on it. The terminals would be uninsulated and probably BA thread with all the (electrical) metalwork being nickel plated.
Chris.