Quote:
Originally Posted by T Creighton
Hi Lionel,
To give you an idea of costs.
I have just had my Morris bearings white metaled (I think that is the same as babbitt)
Mains cost $800nz total, metaled, fitted and line bored.
Rods cost $130nz each metaled and machined and fitted to crankshaft.
This was plus our GST of 15% which you would not have to pay.
Regards, Terry
|
Hello Terry,
Unfortunately GST is alive and well here Terry
Thanks for the list of the prices. Pardon my ignorance of Morris vehicles - are you referring to a four cylinder engine? As in the Chevy being a six cylinder motor ....
I am hoping that the engine will simply be pristine and needs no work done on it at all - just a good clean
teehee!
Kind Regards
Lionel