Thread: M216 Cdn
View Single Post
  #34  
Old 12-11-18, 11:23
Ken Smith Ken Smith is offline
Registered User
 
Join Date: Apr 2008
Location: Qld Australia
Posts: 236
Default

Good day,
After work, I cut the accelerator modification plate off the pedal, the 1/4" plate had been welded to the little pivot point ears at the bottom of the pedal and about half way along the pedal, I have no idea how the fellow welded the plate to the ears without destroying them, but he should get a medal. I cleaned the remains of the weld off and then bead blasted the bottom of the pedal, I also gave the hard rubber a very light touch and it came up very nice.
I made a pivot pin out of a 5/16" bolt that I had brought from home. It is interesting how GMC solved the problem of making the pivot pin a fixture in the pedal, and pivoting in the bush located on the floor. They simply ground off the sides of the pin at one end, and it fits into a hole with 2 flat sides so that it pivots with the pedal movement.

I gave the dipstick tube a very light blast, and a then a blow off with a lot of air. I have pushed a piece of rag through the tube a lot of times, I freed up the nut at the bottom so that I could put the tube back in the engine without having to turn the whole tube.The pedal and the dipstick then got a coat of red oxide.

When I got home I gave the 2 pieces a covering of olive drab. This was very rough as I have had the spray cans for a fair while and they block the little directional fan nozzle very easily. Because I don't like wasting money I pulled the little fan nozzle out and just used the main bigger nozzle which then dribbles a little bit, I didn't mind a lot of paint under the pedal. The dipstick tube faired a little better as the drips fell on the gravel.

Next was getting the remaining 4 seat mounting bolts out which took a little bit longer than planned, it was a nice surprise to find that when the drivers seat was shifted from left to right they had managed to use one of the floor plate captured nuts, so it undid nicely, the other bolt got the 4" cutting disc.

A photo of the rough underside pedal paint job, and the dipstick tube.

Click image for larger version

Name:	M216 Cdn Accelerator pedal with pivot pin.JPG
Views:	1
Size:	334.0 KB
ID:	103487

Click image for larger version

Name:	M216 Cdn dipstick cleaned & painted.JPG
Views:	1
Size:	493.1 KB
ID:	103488
__________________
1940 Cab 11 F15 1G-8129F
1941 Cab 12 C60L AIF L4710841 Middle East veteran
1941 Cab 12 F60L ARN 45818
1941 Cab 12 F60L ARN 46660
1941 Cab 12 F60L ARN 51720 A/T Portee
1942 Cab 13 F15 ARN 55236
1942 Cab 13 F60L ARN 58171 Mach "D" Loading
1942 Cab 13 C15 ARN 62400
1945 Cab 13 C60L ARN 77821
1941 Chevrolet 3 Ton GS ARN AIF L16070 Middle East veteran
Canadian REL (APF) radar trailer
Reply With Quote