[David Dunlop]

Hello Grant.

Yes, that is the wee beastie! Thanks for tracking it down and posting the info.

Interesting that it is the earlier VT9 as opposed to the later VT9A. I suspect the differences would be subtle and very likely, the leads and probes from both the Hickok 209 series of meters and the Stark series of VT9 meters would be fully interchangeable.

For comparison, I have attached a photo of my Hickok 209A. Note the main difference is a minor relocation of a few controls by Stark and that Hickok had the functions rotate with the switches against fixed markers on the front panel, whereas the Stark version of the meter used the switch as the indicator with the functions fixed on the front panel.

If you are familiar with typical vintage VTVM equipment, these two photos will be deceiving. This Hickok/Stark meter is 16.5 inches wide, 13.5 inches high and 8.5 inches deep, weighing in between 15 and 20 pounds. Notice the Hickok handle is a basic bent steel rod format, whereas Stark went with something a lot more comfy.

David