I've been looking for the drawings or in this case full size templates of all the bits and peaces and how to fabricate the side panel. I’ve found all the templates but I trim the parts to fit to much to be of much uses. But I still have both of Bobs panels on the bench next to the one I made so I will sit down with the CAD and see if I can’t come up with a set of drawings for making useable panels. As you can see on my web page
http://canadianmilitarypattern.com/SheetMetalWork.html the panel that I made is a good fit but is not an exact copy as I did not have the tools to make up some of the compound curves which were made by stamping the parts.