View Single Post
  #34  
Old 17-07-18, 00:02
Jacques Reed Jacques Reed is offline
VMVC
 
Join Date: Jul 2012
Location: Victoria Australia
Posts: 858
Default Ford CMP truck- cowl wiring diagram, 2 headlights

Hi Keith et al,

That diagram was a great help. Attached is a wiring diagram I made which may be of use to fellow restorers. Between your diagram, the remnant of a dip switch with a bit of the harness left, and the remnant of the cowl harness and terminal blocks I think it is all correct but, as always, glad to hear from anyone if there is an error.

There are some wires not listed in the Parts Manual wiring diagram but on your diagram due to the two headlight configuration: namely 1a, 2a, and 4a

The wire gauge sizes are off your diagram and match the remnants I have found. The lengths are the wire lengths as measured off the cowl harness from bullet to terminal. The lengths of the dip switch harness wires are my best estimates and may require adjustment.

The turn signal wires are purely for my benefit to agree with the Falk turn signals I have installed.

Cheers,
__________________
F15-A 1942 Battery Staff

Jacques Reed

Last edited by Jacques Reed; 28-11-18 at 09:02. Reason: Changes to diagram.
Reply With Quote