Quote:
Originally Posted by Jacques Reed
Hi Tony and Grant,
As this is a forum to exchange hints and tips here's a good one I have used occasionally which may be of interest:
Measuring things that have curvature or bends is hard to do with a tape measure due to its rigidity. I keep a bit of plastic banding tape used on heavy packages and run that around the object with appropriate tick marks then lay the banding tape out flat and measure that.
In the old days that tape was handy for opening car doors if you locked yourself out but modern designs render it ineffective.
Cheers,
|
Keeping in mind what Jacques has mentioned above... I have continued to do measurements the fool way I have previously posted.
Jacques
me
The holes middle to middle are 3 and 1/4 inch.
Repeat 3 and 1/4 inch.