The brakes I am referring to are the steering brakes inside the differential housing. I see no way to change them around without redesigning the mounts on the inside. They work OK but it is noticeable that they work better when I back up.
The normal drum brakes are just fine for stopping. I made pedals for the drum brakes instead of using the 4 tillers of the T16. I then joined the pedals together to give me straight stopping rather than run the risk of one turning me at a time when I need to stop. I made them separate in case I decide to try steering with them, don't see the need most of the time but if I broke a linkage pin....... might be the only way to get back to the barn for repairs. I am always planning for worst case scenarios....