Exhausting work......
Just after the New a Year, I dropped an original exhaust pipe into the local muffler shop to get them to bend the pipes and find some mufflers that were as close as we could get to right dimensions. I picked up the components from the shop on Thursday and spent the long weekend fabricating and fitting them.
There were a few issues, the first being that I could not get the pipes mandrel formed locally, so had to contend with changing pipes diameters caused by press forming. The second issue was that the mufflers are close but not identical to the originals - The main difference being the that inlet and outlet pipes are 2 1/4” (pipes are 2”) and about 1/2” further in from the edge when compared to the originals.
The change in piper diameters was overcome by turning up some bushes, this allowed me to, starting at the bottom, position everything then weld the pipes to the bushes, whilst allowing the bushes to sit snugly in the muffler.
Once everything was cut, assembled and tacked in place, the top pipes were welded to the muffler and the original cut offs on the lower pipes were welded in place before a (incomplete) coat of paint was applied.
__________________
Phillip Thompson
"He who has the tiger by the tale, is often afraid to let go" - Confucius
Ford FGT No.9 (long suffering restoration project)
25 Pdr (Under Restoration)
No.27 Artillery Trailer (Under Restoration)
Bit and pieces of a 2 pdr AT (Looking for bits)
LP2a Carrier - 3" Mortar Trials (Restored)
Last edited by Phillip; 28-01-18 at 10:42.
Reason: Grammar
|