19 Set pics
Here's some shots of the various bits. The first shows the factory supplied 11 set base bolted to the running board. The 19 set adapter plate is leaning loose above it. You have to remove the 11 set rails and install the 19 set ones using the same (outer) set of holes.
Then there are four rubber 'feet' that bolt onto the adapter plate and then to the underside of the 'Carrier No.22' which is what the 19 set sender/receiver is fastened to with the canvas strap. There is a secondary sheet metal plate with a junction box that also fits the same holes at the right (or vehicle rear) side of the set. The supply unit sits sideways on top of the sender/receiver held in place by two metal angles that are screws to the top of the set, two 'pieces packing' and a canvas strap.
|