[Jordan Baker]

Ive also got NOS fastners for the vision covers. I only have to re-drill my holes to fit them and then eveything should bolt right on. The pile of rusty bits near the top of the photo is what I had left of the original vision slot covers. Un fourtunatly they had been cut up a bit and were no longer good to use other then for patterns.

The only fastners I couldn't find were the flat washer types. These had a cotter pin insterted into a collar. The collar was located between the hull and the striaght pivot arm.

The pink blocks just to the right of the left most cover is the mould for the knob.

Unfourtunatly the Illustrated part cat didn't have any drawings what so ever for the vision slot covers. But I have figured out where everyhting went and what part numbers when with what parts. I will hopefuly get some drawings made up and post them so others could use them.