Quote:
Originally Posted by Jonathan Moore
. So, I have taken the plunge and I am having new two part half shafts made in the UK for both sides. These will consist of the shaft and a separate splined driving flange. Unfortunately but predictably, the flange will have to be thicker than the original and I will make an end cap to replicate the look of the original but its better than not being able to use the vehicle. Its will be about 8 weeks before they are ready so I will let you know what happens.
|
Jonathan
I was lucky in finding a second original set from a scrapper...but I think you have a good solution going and probably a bit stronger than the old ones.
Can I ask you for the measurements of the rear seat? as this is on my list for this years project.. thanks
Pieter