(1) Did you use the molasses on the inside of the tank as well???? Answer: Yes, but the molasses treatment revealed hundreds of pin holes in the old tank, so we had to throw it away and have a new one made out of stainless steel.
(2) Did you apply a sealer inside the tank? Answer: Yes but probably not needed.
(3) Did you ever established if the steering wheel box was originally the same as a CMP? Answer: No, but some of the NZ civilian Chevs (including ours) had that heavier style of steering column.
(4) What were the inaccuracies of the front fenders...... where they join the stepping boards??? Answer: The bottom curve of the fender curves round too much – (compare with wartime photos). Also the fenders should be 100mm wider to accommodate the wider Timken front axle and the wider tyres. The cost of remedying that was a “bridge too far” for us.
(5) Are you using a stock rear axle from a 4x4 CMP?? or from a C15 4x2?? Neither – Answer: its just the original civilian axle for a 30cwt truck.
Last edited by Andrew H.; 13-02-22 at 21:12.
|