With the floor secured and the side panels mostly attached I was able to turn my attention to the rear most cross member which fixes the rear corners but is not supported by the chassis. As this piece is missing on all my utes I have no real idea how it is formed. There is evidence that the bottom of the rear inner corner panels screw to the timber but the holes are small and it does not look strong enough to properly support the corners. I decided to just make it strong enough. I put a 28mm thick piece of timber each side of the corner piece and inserted four 10mm bolts through the lot. The rear section was squared up and clamped in position first so I got the rear tailgate opening nice and square. The ends of the floor strips were then screwed to this timber. Once this was done I nailed the inners corner panel to the corner timber pieces. The back feels very strong and solid.
__________________
1943 Willys MB
Willys Trailer
1941 Fordson WOT 2H
1941 Fordson WOT 2H (Unrestored)
194? Fordson WOT 2D (Unrestored)
1939 Ford 1 ton utility (Undergoing restoration)
1940 Ford 1 ton utility (Unrestored)
1941 Ford 1 ton utility (Unrestored)
BSA folding bicycle
BSA folding bicycle
1941 Ford/Marmon Herrington 3A gun tractor
1941 Ford/Marmon Herrington 3 gun tractor (Unrestored)
1941 Diamond T 969 (Unrestored)
Wiles Junior Cooker x 2
|