Thread: Low compression
View Single Post
  #49  
Old 07-02-18, 00:21
Jim Burrill Jim Burrill is offline
Registered User
 
Join Date: Feb 2003
Location: Hatfield, PA, USA
Posts: 429
Default

HD oil issues - My Humber Mk4 Armoured car had an engine rebuild at the shop in the UK. With less that 50 hours of run time, we burned up no4 Main bearing.

The final understanding was that during the engine rebuild, two oil channels (which has a freeze plug type cap on one end, and a bolt on the other) was not opened and cleaned out.

We put HD oil in for our running in.

Apparently, it dissolved the sludge and circulated it to the oil sump/pan. The pick-up for the oil pump has a metal wire filter. That was completely sludged over. The resulting oil starvation caused #4 piston main bearing - a poured babbet bearing - to melt.

We had a machine shop remove all the babbet bearings and switched to cap bearings.

We are better off having cleaned the oil journals, but some $4,000 poorer for having to pull the engine and the rebuild.

So.... no more HD oil for my stuff!
Reply With Quote