Chris,
I think any Holden clutch plate from 60's to 80's will fit (I have put one in a Chev blitz with no problems). Don't know what bolt pattern is on the flywheel you have as even the 216 motor had a couple of different patterns which sends you insane trying to make one motor out of two and swap pressure plates around. The clutch plate,11 inch from memory, should fit any pressure plate. You don't need to hunt up a V8 clutch plate, if indeed they were different to the 6 cylinder as the Holden Red motor had more power than the Chev anyhow and could handle that engine with comfort. Dave M should know everything about this anyhow.
Lang
Last edited by Lang; 07-08-12 at 11:36.
|