Thread: How To: C15a Wire-3 restoration
View Single Post
  #612  
Old 16-06-19, 14:20
Phil Waterman Phil Waterman is offline
Moderator
 
Join Date: Feb 2003
Location: Temple, New Hampshire, USA
Posts: 3,927
Default Dash Wiring

Hi Jordan

Your truck has one more hole comin in from the engine compartment than I've seen before, wonder if it was drilled to replace a wire or possibly for a replacement temperature gauge tube.

Here is same area on my HUP
Click image for larger version

Name:	Small Web 2012 HUP June 029.jpg
Views:	41
Size:	221.2 KB
ID:	107860

As you have discovered the only practical way to work on the dash and engine compartment wiring is with nose off. I make this comment to anyone planning to replace or do major work on the wiring in this area.

Jordan though I'll guess you have looked at the section on wiring on my web page, here is the link for people getting into wiring on thier CMPs http://canadianmilitarypattern.com/C...formatioSn.htm I've included the link instead of posting over all the photos because you can punch down to much higher resolution than is practical on MLU.

Cheers Phil

PS In response to Davids comment on vacuum line, the vacuum line for the wipers on mine goes up through the center post on the windshield.
__________________
Phil Waterman
`41 C60L Pattern 12
`42 C60S Radio Pattern 13
`45 HUP
http://canadianmilitarypattern.com/
New e-mail Philip@canadianmilitarypattern.com

Last edited by Phil Waterman; 16-06-19 at 14:24. Reason: add information
Reply With Quote