Quote:
Originally Posted by David Dunlop
Thanks for posting that info, Simon. The more knowledge in the pool, the better!
David
|
Thanks for that. I fear the flow of information will all be one way though.
I have so far cosmetically restored my No 23 breadboard(which was unpainted from new), the EKCo Mk III 19 set, Pye PSU, variometer and control box and am gradually acquiring the missing bits to complete the installation.
I know that each set of the shock absorbing mounts have two metal strips which go either side of the bench top. I have assumed that these are 1" wide and half an inch longer at either end. I have used 1.5mm plate. Is that about right?