Started working on the left fender today. It was a bit beat up and no longer had the nice curve to match the right side one. I traced out the right side curve some plywood to act as a guide while fixed the fender. As the metal had been stretched and warped I have had to cut it so that it would bend. It is slow work but it should get it back close to the original shape.
__________________
Jordan Baker
RHLI Museum,
Otter LRC
C15A-Wire3, 1944
Willys MB, 1942
10cwt Canadian trailer
Last edited by Jordan Baker; 12-09-16 at 21:28.
|