[Jacques Reed]

Good Day,

Ticked off another loose end. Started fabricating the last fuel line a while back but got a bit sidetracked with the transmission rebuild.

So yesterday I finished off the fuel line from the left side fuel tank to the changeover valve. Again, the parts truck junk was invaluable as a pattern. The clip that holds it to the running board support adaptor was too wasted to reuse so another small fabrication job was required.

So that completed all my Bundy tube bending for the truck. fuel lines, brake lines and even the lines to and from the bypass oil filter. Must be quite a few metres all up not including the lines I redid after getting corrected information.

Time now for a Bundy and Coke! Bundaberg that is.

Cheers,