hi are the measurements on this ross discharger listed on ebay correct 10 inch long 4inch ID 4 1/2 inch OD as i am going to make a dummy tube.
also what is the thread thats on the end ? and i take it the adaptor is a male /male threaded nut type thing ?
I got around the problem of cutting off the bracket its lucky that the holes on the mk2 bracket fell inside the deep water bracket plate, so i drilled and counter sunk the two holes in the deep water bracket and just put flat slotted c/s bolts in looks like a propper army mod now, should have thort about this when building the new sides but didnt think i would find bits like a 4inch smoke discharger bracket i made a simular mistake with the rear wings/ mud guards copied a pair that were off a carrier with a tow hitch then altered the to fit mine with out now ive found a hitch assembly so have to cut them out again....... Bloody typicial
|