View Single Post
  #384  
Old 12-09-17, 19:42
Richard Farrant's Avatar
Richard Farrant Richard Farrant is offline
Registered User
 
Join Date: Feb 2003
Location: Kent, England
Posts: 3,634
Default

Quote:
Originally Posted by colin jones View Post
Here's a bit better picture of Platypus dash.
Colin,
The water temp gauge is missing in the photo because there was a leak in the capillary tube and it had gone back to the instrument shop. The starter button at top left, switch was a common Lucas item, still available in 1970's, heavy duty type, we made the flap cover and flange which was mounted on face of panel and switch faced up on back side. Three toggle switches, first one is on/off/on for the red or blue tail lamps, second one is for the front side lamps, off/on, then the third is the magneto switch, off/on.

At the bottom on the left is a small square item with two screws securing it to the panel, and a large hole in the centre. This is the horn button, replicated it from a photo, I used a normal small Lucas push button switch and made the cover, inserted a brake cylinder cup seal of suitable size, worked fine and look right. the large brass switch was rather elaborate as it was for dimming the front side lamps, there are no headlamps on these.
More to come later on ......

cheers Richard
__________________
Richard

1943 Bedford QLD lorry - 1941 BSA WM20 m/cycle - 1943 Daimler Scout Car Mk2
Member of MVT, IMPS, MVG of NSW, KVE and AMVCS
KVE President & KVE News Editor
Reply With Quote