[cliff]

Originally Posted by Tony R

Thanks Cliff for putting me right, very informative. This forum is a great place to increase ones knowledge.

So, if one was to re-create a LRDG Chev, a good start would be to mate an open cab GMC front (converted to RH drive) to a cut down closed cab rear? The reason for asking is that I recently acquired a 1 1/2 ton Chev and was contemplating doing this as a project. Now I better understand how the trucks were first built, it gives me a better idea of the task in hand.

Regards to all.

Tony what country/area are you located in? makes it easier for us know where you are located.

I am not 100% certain but I think you will find the open cab GMC-CCKW cowl is totally different to the flat cowl Chev of the same period. For instance the Chev bonnet probably does not fit.

The photo below is of a replica LRDG Chev in England I believe.