WS A Mk 3

[Tim Bell]

Wireless A Mk 3 - Normal

This is in Waterproof Container "C" and has the regular set up - with a Pull Switch allowing the operator to choose between a Battery Power source and Mains... and a Mains Plug board which allowed the operator to choose the input voltage.

20160420_124046-1.jpg

Wireless A Mk 3 - Modified

This is also in Waterproof Container "C", but has been modified (all modified parts are Australian - am assuming SOA use - confirmation required) - with a Pull switch which allows the operator to choose between a Battery Power source and Generator... So... No Mains input... presumably because Mains Power was not that common where the set was used.

20160420_124224-1.jpg

Wireless A Mk 3 - Hand Generator, 6v PSU and Spares

Waterproof containers:

"F" - Hand Generator with table clamps (not exclusive to WS A Mk 3)
"D" - 6v PSU and Spares

20160420_122723-1.jpg

20160420_122856-1.jpg

20160420_123005-1.jpg


Hope the above is of interest.