Further adventures with a Ford flat head engine

[Alastair Thomas]

I am slowly making progress with the replacement engine for our F60S LAAT.
My last post on this subject was about the trauma of removing the valves. This chapter is about building engine stands and checking the block for cracks.
I have appended the story in the attached .pdf document.

Going forward I will soon be reassembling the engine. I cannot find the torque settings in my operator's manual nor in the workshop manual. Can anybody help. I particularly need the values for the big ends, the main bearings, the head nuts and the flywheel bolts.

Kind regards,
Alastair
F60S LAAT
Ford Lynx I MkIII*