Ford Blitz Restoration/Rebuild

[Private_collector]

Courtesy of unsatisfactory results first time, a new pair of the corner tabs for my rear window curtain were made this evening.
20161011_200946-resized-1024.jpg
The first ones I made, like the originals, had a single fold hem only (see left side, following photo). I fully expected real problems with that at some point, and besides, they looked REALLY horrible when folded back to expose underside. Yuck! The one on right hand side of same photo is my second type.
20161011_200732-resized-1024.jpg 20161011_200813-resized-1024.jpg
The side view (right hand photo above) illustrates the increased thickness of second attempt. These are basically two like the first ones, sewn back to back and with diagonal stitching for added strength.
20161011_202429-resized-1024.jpg
After a brief search, I found the eyelets I had bought some time ago for this specific job. They will also be used for the canvas part of the sunshine cab roof.

I urgently need to see what the springs look like that pull the corner tabs down and laterally, holding the canvas curtain taut and stopping any flapping around. I have the right angle brackets that hold the other end of the spring to rear cab panel, but have never (so far as I know) seen an example of the springs themselves. If you have a photo of these, I would be most grateful to see it.