|
|
#11
10-11-15, 07:19
|
||||
|
||||
David,
Been looking into Cricut machine capabilities, and see it should be able to do stencils, provided you use a deep-cut blade. Oilboard would allow you to do multiple stencils from a single piece of board, BUT it seems to be quite elusive for purchase online. At least it is hard to find in blank sheet form, and in a size suitable for Cricut. For that matter, I didn't see any suitable for my machine either. Using paint-mask film will give you exactly the finished product needed to do vehicle numbers or lettering. You just can't reuse it.. I've not used paint-mask yet, but am keen to try it when I can. Added 1715hrs: Oilboard sheets and rolls available here http://www.hittmarking.com/category/...ets-and-rolls/
__________________
Ford CMP, 115" WB,1942 (Under Restoration...still) Medium sized, half fake, artillery piece project. (The 1/4 Pounder) Last edited by Private_collector; 10-11-15 at 08:13. 
|
|
|
Threaded Mode