|
#1
|
|||
|
|||
Question - 19 set power supply.
On the six point power input cable, what number is the hot
connection and what is the ground. Peter S |
#2
|
|||
|
|||
Quote:
I don't know the answer but,Here is the whole manual with wiring diagrams.. http://www.qsl.net/ve3bdb/manpage3.html It will make a difference as to weather the 19 set is Canadian or UK manufacture..They used different colour codes for grounds and hots... Here is the international wiring colour code charts that make be of some good to you,, http://www.allaboutcircuits.com/vol_5/chpt_2/2.html Good luck
__________________
Alex Blair :remember :support :drunk: |
#3
|
|||
|
|||
Wiring
Should I have said Mk III??
|
#4
|
|||
|
|||
This is for the #2 power supply.
pin1 -12v heaters, -12v dynamotor & gnd pin2 i/c speech pin3 +12v heaters & relay pin4 +12v vibrator & dynamotor pin5 signal pin6 -12v vibrator If working only from the vibrator it is advisable not to power the i/c, A set & B set all at once as it loads the psu. Besides, there's nothing like the scream of a well lubed dynamotor. |
#5
|
|||
|
|||
Cable
I may have confused the situation.
I have a 110/24 volt power supply. It has a cable that connects to the 19 set power supply. The cable has a pos. and neg. lead What pins do the positive and negative connect to on the six point connector? Thanks |
#6
|
|||
|
|||
ok, 24v is a whole different ball game (or hockey).
For a 2 wire 24v supply the negative goes to pin 1 and the positive goes to pin 4. Set the switch inside the power supply to 24v. You can only use the dynamotor position, the vibrator is disabled. |
|
|