|
#1
|
||||
|
||||
WS19 cable
Hi everyone
Anyone able to tell me how to remove the wires from the inside of the 6pin connector. I picked up a junked cable to use the 6pin connector for another cable. I just can't figure out how the wires are removed from the inside. ive taken the outer cover off and the central screw from the front. After that Im stuck. Any help is much appreciated.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer |
#2
|
|||
|
|||
Carefully....
...with a hammer......
__________________
Bob Carriere....B.T.B C15a Cab 11 Hammond, Ontario Canada |
#3
|
|||
|
|||
WS 19 6pt connector
Hi Jordan,
While Bob's method would work it is a bit severe. The approved method would be to: Remove spring clip that holds the top cover in place Remove top cover - it hinges Around the plug body near the pressed ring you will find three slots with a thin metal spring tab protruding through. Push each tab in till they clear the body. Gently push the face of the plug, where you removed the screw, out toward the top, it should just slip out. Cheers, Dave |
#4
|
|||
|
|||
Jordan, the other problem you will discover is that the existing solder will be unworkable. It won't melt and reset, and if there's a trace of it left the new solder won't stick either. I'd attach that cable to a non-working set and get a good one.
Quote:
|
#5
|
|||
|
|||
More details please....
Hi Bruce
Why will the solder behave like that Bruce....? Really curious.... my Dad use to buy old military radios in the 50s to build Amateur radios..... which included a dump truck load of no 19..... he use to keep me busy unsoldering various parts for him....... wires had been cut and I was charged with removing the left over pig tail wire...... I was shown how to use a drinking straw to blow away the melted extra solder from the little holes on the connecting pins. I know he soldered some parts back in various devices but not sure what he used. Bob
__________________
Bob Carriere....B.T.B C15a Cab 11 Hammond, Ontario Canada |
#6
|
|||
|
|||
Solder sucker..
Quote:
Lead solder poisoning..!! Too much solder sucked UP through the straw..rather than blown away..Sever brain damage.. Only cure know to man is a daily infusion of Beer!!! When are we going to Gracies again to help you with your treatments.. make the call.
__________________
Alex Blair :remember :support :drunk: |
#7
|
|||
|
|||
Air force type.....
..... still can't tell the difference between sucking and blowing......
May be something in the offering for Gracies...... the infamous Chris of Nroth Bay is visiting Ottawa...... Caution..... last week when I went ot the chinese restaurant next to Gracies is was closed out dark!!!!! Bob
__________________
Bob Carriere....B.T.B C15a Cab 11 Hammond, Ontario Canada |
#8
|
|||
|
|||
Quote:
Blowsion. (blow je-un). Verb. Eastern Canada (Newfiew) opposite of suction. As in blowing ot'a dere in re'verze bye. |
|
|