CFTO on dual IKEE RT524 radio installation in M38A1Cdn2/3

[rob love]

Here are some photos from the dual IKEE (installation kit, electrical equipment) for putting the 524 sets into the Cdn2 and Cdn3 trucks. The CFTO is rather lengthy, so I am just going to post the basic photos. Here are photos of the 3 different antenna installation points. I have never seen the one on the front right fender.

[BOBM35A2]

Thank You Rob, I was looking for redemption.
Bob M.

[rob love]

Here are a couple more shots from the CFTO, one of the tray setup on the left fender, and the other of the setup for 3 radios. Unfortunately, I can't locate the page with the doghouse and the power distribution box, but I am still keeping an eye out for them.

[Scott Bentley]

On the topic of the IKEE.....

Help!

I was getting my Battery Box and heavy cabling all sorted out today on my 151. Anyway, I had the female end of IKEE Bendix socket and mounting tab, and was getting ready to solder some copper terminals on the running ends of the cables today. Of course, I forgot which wire is which. The big concern is that I need to cut the Ground down so it can be grounded next to the mounting tab. Would hate to cut the wrong one

Heres a pic. The "A" and "B" poles have continuity to an end of a cable respectively, and the "C" must be a blank. Which one is which?



Rob, any chance you have the CFTO that shows all of the IKEE mounting in the 151, specifically, from the Battery Box to the Bendix? I want to make sure i'm getting it all installed correctly.

Thanks

[rob love]

The Bendix connector installation was specifically mod C30-105-000/CF-001. As I recall, the A is power, the B is neg, and C is blank.

[Scott Bentley]

Rob, once again... You are the Man!!

Thanks

Scotty