Unsavoury Discovery

Ganmain Tony · #1 29-09-10, 03:46

Made this discovery on the right hand rear axle a couple of weekends ago. Very upsetting.

All the studs were quite OK when I put them in during the restoration. Had all the right washers and nuts.

I havent checked the wheel bearings for play yet but I intend to and will post result of findings.

I have since drilled out the broken studs and replaced them with ones from a Studebaker rear axle. Exactly the same threads just the Stude ones where slightly longer on the nut thread.

This side had a slightly twisted axle and I replaced it with one from Max's which was and still is in perfect order.

Anyone had a problem like this before??

Robert Farmer · #2 29-09-10, 04:53

Never happens with a Chev!!!!

Ken Hughes · #3 29-09-10, 05:53

See, too much power!.

Harry Moon · #4 29-09-10, 06:43

Do you have the "keepers" underneath or lock washers? The lifting sling plate should float a little.

Ganmain Tony · #5 29-09-10, 11:03

I take it Harry the keepers are the conical shaped washers? If they are, then yes they are there.

I agree with you, they would spread the load on the studs.

As Ken said....the problems that arise with having the right amount of cylinders under the hood....too much grunt!!!

Cameron Reed · #6 29-09-10, 16:44

just looking at the shots, and wondering if the other ones left were still tight. In the first photo,is the hub look a bit discolored or is it not washed or maybe a little heat.the second photo the stud at 8 o'clock looks to have been broken 1st. If the bearings checked out good maybe try to mount a dial indicator to the end of the axle tube (where the adjuster nut is) and check if any or how much runout there is in the face of the hub with the other studs out when you spin the wheel (hub) should even be able to leave the wheel on (bloody heavy buggers) hope its of some help other wise i agree it's the brute hp of the sv ford, maybe got a 4.00"merc crank in her