How To: Ford CMP "Blitz" miscellany

[Jacques Reed]

Good Day,

I just received the prototype engine and transmission data plate from the laser engraver and I am very happy with the results. I liaised closely with him to make it as close to original as possible. I have already informed him to increase the left and right borders by 2 mm for those who spotted it.

As previously mentioned it is black anodized aluminium with the thin black anodizing, laser etched to reveal the aluminium beneath. The depth of the etching is microscopic, so no deep lettering or graphics.

Same material as original, aluminium, but a modern process to replicate the appearance.

Original F15-A plate is at top from which the common artwork was developed.
Middle scan is the F30/F60 prototype.
Bottom photo is an F60 plate from which the Auxiliary Transmission pattern was obtained and the relevant quantities for the larger trucks.

I will get them produced depending on interest shown. Anticipate they can be done for under $30 each. Will know exact amount once I have an idea of quantities to produce. PM me if interested.

Cheers,