|
|
#33
14-08-08, 22:55
|
||||
|
||||
Thanks for the snaps Rob,
Although its an M38A1, like you said before, its still the correct 1/4 Ton cam pattern. I've decieded that pattern will be my end state in paint. Well, I finally got a hold on the Red Deer A2. After flushing the fuel system and doing a few checks we got it fired up. It runs quite well right off the bat, but it looks like i'm going to need to buy a Timing Light/Tech Dwell Meter as both the Carb and Distributer are recent NOS installs and havn't had any fine adjustments done yet. Rob, you wouldn't happen to have a line on another AMU Mounting Bracket like you have on the rear left corner of your M38A1? This 74 has all of the holes and wear marks from one that was removed when it was demiliterized, and i'd love to get another one. Actually, while i'm at it, if anyone has any lines on an RT524 with Tray, or a PRC77 Set and a 2060 Tray, i'd be very interest in them. I'd like to try and get a Radio installed with the Restoration. Scotty B 
|
|
|
Threaded Mode