MLU FORUM  

Go Back   MLU FORUM > MILITARY VEHICLES > The Carrier Forum

Notices

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 22-09-08, 23:44
Big D Big D is offline
Darryl
 
Join Date: May 2008
Location: Dunedin, New Zealand
Posts: 661
Default Carrier ignition electrics

Gidday all,

I have another wee issue with the carrier I recently bought. I’m not sure whether I am confused about how the ignition system should actually work and be set up, or whether something isn’t quite right.

I’ve noted that it was a bit of a hard starter since I had it. I put it down to the technique I was using and perhaps also the change in location. The previous owners always found it a good reliable starter.

One thing I did notice was that when it was stubborn in starting, the spark at the plug seemed really weak, almost as if there was a kill switch somewhere. By chance I found if I turned on the inspection lamp switch, the carrier would often start (dependent on whether I’d flooded it or not I think). Once it was running though, if I turned off the inspection lamp switch, it would make the engine stall.

From what I remember, turning this switch on wasn’t part of the startup procedure when I first looked at the carrier, but I’ve sent the previous owners a message to confirm this.

I did some more checking on the electrics. The coil appears to be an original type Ford 4.2 volt coil. I got my voltmeter out and found that with just the ignition switch on, the voltage at the coil was 1.97 volts. When I switched the inspection lamp switch on, the voltage rises to 4.2 volts at the coil.

I pulled out the control panel for a closer look and I’ve attached a photograph which might hopefully show the wiring a bit better.

The white wire on the ignition resistor is coming from the ignition switch. The blue wire from the resistor goes to the coil.

I’ve noted that there is a connecting wire (the thin red wire in the picture) running from the coil side of the ignition resistor to the inspection lamp switch (the non-live side). The other side of the inspection lamp switch is a ‘live’ line coming from the fuse box.

When the inspection lamp switch is turned on, this effectively puts 6 volts to the coil side of the ignition resistor.

I can’t find a reference to the ignition resistor in the spare parts manual but this one measures 2 ohms. Presumably if that 6 volts is going to the coil when the inspection lamp switch is turned on, it is still being 'stepped-down' somewhere before it hits the coil?

Have I missed something here? Should the inspection lamp switch be part of the ignition system?

Was this setup just part of a cunning move by the previous owner when he did the ignition?

Is there any reason why there would be a feed between the inspection lamp switch and the ignition resistor?

I guess I could just leave it as is and have the inspection lamp switch on all the time, but I'd like to know I have things right.

Any thoughts would be appreciated.

Thanks.

Cheers

Darryl
Attached Images
File Type: jpg Img_3296.jpg (139.6 KB, 103 views)
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +2. The time now is 03:01.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © Maple Leaf Up, 2003-2016