|
|
#30
17-02-09, 22:57
|
||||
|
||||
Rifle Butt Holders
Below are pictures of the holder I have. I've yet to use a router to do a second but that's one of those lesser needed objects!
In any case, the holders are of wood, what type I don't know. The measurements are: Heighth: 1 3/4" Width: 2 7/8" Length: 5 7/8" Inside depths: 1" to 1 7/16" The inside "floor" does slope. Wall thickness: 5/8" Mounting holes are 2 7/8" on center, at least for my F8. They are 1 1/2" on center from each end. Hope this helps! Regards, Jim 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Reference: CMP tool box and spare tire holder plans | George McKenzie | The Restoration Forum | 37 | 25-12-22 15:30 |
| LP2 VR 2225 Build | Dale Jordan | The Restoration Forum | 255 | 25-07-18 08:45 |
| For Sale: Carrier/Truck Tool | B. Harris | For Sale Or Wanted | 11 | 05-05-15 08:52 |
| Reference: Ford CMP Truck- Battery Holder plans | Jacques Reed | The Restoration Forum | 14 | 17-09-12 23:35 |
| My GM engine number when was it build?? | 8threcce | The Restoration Forum | 7 | 09-01-12 09:39 |
Threaded Mode