|
|
#29
02-04-10, 09:18
|
||||
|
||||
Thanks Mike, I’m more than happy with the way it has turned out, given I have never tried anything like this before.
Am doing up the brake system on the truck at the moment. Have put a new kit into the master cylinder (which had 1¼” stamped on it but had been resized with a sleeve to 1”, quite new). The front and back brake cylinders are two different models Front has 2 S 231 stamped on it, not original I think, and back Delco 5450072 that are original as per part book. Both are 1 3/8 cups. The handbrake cable on the passenger side was hooked to nothing. The picture below is of the handbrake assembly for the drivers side. Anyone have any ideas on where I should be looking for the parts I need for the passenger side handbrake? Mick 
|
|
|
Threaded Mode