|
|
#1
03-09-11, 02:41
|
|||
|
|||
drawings and welding hints
Does anyone have , for a MkI*:
1) a dimensional drawing of the bulkhead seperating the front and rear comartment? including 2) engine cooling shroud/intake? The driver's side of the bulkhead of my carrier was cut shorter than the gunners side. Has anyone had luck welding sections of new steel to the bulkhead rather than replacing the whole thing. If yes did you use mild steel or alloy? Thanks again all!
__________________
Ralph Volkert UC 2Mk I* Upper Hull: CB 8075 Lower Hull: 8105 S/N: 9075 Date: Jun(est) 42 contract #: CDLV 213 1946 Willys Jeep 1974 Plymouth Road Runner 1987 Trans Am 
|
|
|
Threaded Mode