Richie's Mk1 Restoration

[RichardT10829]

Originally Posted by horsa

Rivets were a manufacturing method used all over Canada and the UK (and really everywhere else) during the war and was the fastest and easiest way to employ a large percentage of the available workforce to speed up production. The USA had started new techniques welding Liberty ships and was able to turn them out faster than when they had been riveting. The T-16 was produced after that time so was able to take advantage of it while automatically gaining a relatively water-tight hull for possible amphibious use.

I still also prefer the rivet look myself but alas, it wouldn't be correct for my carrier. Course the T-16 has a stronger hull whereas other models had the easy opening feature.

I cant recall but i am sure this one was either hit by an 88 shell... or struck an anti tank mine... they all peel open one way or another lets face it with the size of round being fired at them the 10mm front plate was like having tracing paper as a shield...


well back to the grind stone... speaking of which my die grinder and roloc discs should be arriving today.... i cannot put off moving my big compressor any longer....the thing weighs a tonne like a mini sub ! need to go turn out a few snaps then harden them.... an engineer i know was saying to quench it in Brine rather than oil as it pulls the heat out faster..... that combined with heating the steel up until its glowing then roll it in carbon...then re heat and quench...

anyone else heard of this ?